Date Registered: 06-2018 Location: Emerald, Victoria TOTAL POSTS:17
|
T31 reversing camera wiring Greetings all. I'm using a wi-fi reversing camera and would like to connect to the reversing light circuit for obvious reasons. I've removed trims above the rear windscreen and removed the two screws holding the L.H. tail light cluster in place. The tail light is still very securely attached and resistant to pulling . Should I just pull harder? Is it glued or clipped in place? The rubber boot where I'll need to pass the wire through seems very well attached also. I'm hoping to pass the wire through this rubber boot then fish it out with a wire hook or similar. I wonder has anyone had the experience and able to help at all? Grateful for ant suggestions.
Keep will in these scary times.
--- Arwie ID X 5507
2012 T31 St-L Series2 CVT Brilliant Silver. No mod's
Date Registered: 08-2013 Location: Canberra TOTAL POSTS:115
|
Re: T31 reversing camera wiring Why not become a full member, download the complete service manual, and see where to break into the wiring from under the bonnet/inside the cabin? Much easier than pulling the car apart in an effort to locate the correct wiring.
--- 2013 ST, T31 Series 5. Aug, 2013
Member X-3280
