Revhead Kev
Date Registered: 10-2006
Location: Mona Vale, Sydney, AUSTRALIA
TOTAL POSTS: 6360
|
 | 
|
|
Re: Centre Bearing
Best way is to source a replacement rear drive shaft from a wrecker like Jamie did in this thread.
--- Kev X450(c) T30 Guru
03 Titanium Ti T30 Series 1 **MODIFIED**
My Blog
My CarPC Worklog |
|
23/Apr/2013, 9:23 am
|
|
Revhead Kev
Date Registered: 10-2006
Location: Mona Vale, Sydney, AUSTRALIA
TOTAL POSTS: 6360
|
|
|
|
|
Re: Centre Bearing
When you say "move" which way do you mean ... inline with the tailshaft or perpendicular to it ?
Last edited by Revhead Kev, 2/May/2013, 10:17 pm
--- Kev X450(c) T30 Guru
03 Titanium Ti T30 Series 1 **MODIFIED**
My Blog
My CarPC Worklog |
|
2/May/2013, 10:17 pm
|
|
cooch t31
X-TRAIL HOLIC
Date Registered: 06-2008
Location: Blue Mountains, NSW
TOTAL POSTS: 5966
|
|
|
|
|
Re:
Either way that is a lot of movement full stop, providing the tail shaft is still bolted on.
Shouldn't move that much if any thing at all.
Last edited by cooch t31, 3/May/2013, 6:10 am
--- Tony X-891c
HERE is my D22 Navara
HERE is my old 2008 T31, ST Series1
|
|
3/May/2013, 6:09 am
|
|
Revhead Kev
Date Registered: 10-2006
Location: Mona Vale, Sydney, AUSTRALIA
TOTAL POSTS: 6360
|
|
|
|
|
Re: Centre Bearing
The only play I had on mine was about 1-2mm up/down on the rear of the transfer case, but I know that has a stuffed seal and bearings...which are being replaced now. Before that, nothing.
--- Kev X450(c) T30 Guru
03 Titanium Ti T30 Series 1 **MODIFIED**
My Blog
My CarPC Worklog |
|
3/May/2013, 5:45 pm
|
|
