Date Registered: 10-2006
Location: Mona Vale, Sydney, AUSTRALIA
TOTAL POSTS: 5395
Re: How to Reset/Reprogram your ECU - T30 Series I & II
Most toggle switches are meant for heavier currents and higher voltages than you will find with your pedal sensors so I expect that the switch contacts are just a little worn or some oxidation has formed because the currents were not high enough to stop it.
If you get another toggle switch, making sure it is for low-level signals by having wiping contacts then you should find it will be OK again and last longer before it interferes with the signals to the ECU again.
Also, if there is a difference in the sensor impedance between the two pedals for throttle off position then that might cause some issues with the ECU on change-over which a pedal relearn should fix.
Kev X450(c) T30 Guru
03 Titanium Ti T30 Series 1 **MODIFIED**
My CarPC Worklog
10/Mar/2014, 5:30 pm